Mitsubishi PLC FX2N & HMI E1000 Networking using BDTP Technology


Networking between E1000 terminals using
BDTP Technology.      


 1.   Material Requirement


The required material for the setup is
as follows
Sr.
no.
Material
1
PLC Type  : FX Series
2
CPU      
  :  FX2N
3
PLC S/W   : GX Developer Ver. 8.45X
4
HMI   
      :
E1041,E1043
5
Other


 2. Diagram
 
Network
communication via BDTP is used to connect two or more E1000-series
operator terminals to one or two controllers or several operator terminals to
two or more controllers, with retained performance.





Figure 1 Networking between E –Terminals
using BDTP Technology

 Cables
The required cables are as follows
    
Sr. no.
Item
Description
1
Medoc cable
Prog. cable for
FX PLC
2
Ethernet Cross
Cable
Comm. Cable for
E-Terminal to E-Terminal & PLC*1
*1 To connect the E-Terminal to E-Terminal
if HUB is used then Serial    Straight
cable is used.

  
4.  E-Designer
Program Setting
 Set IP 192.168.1.1 of BDTP Server in Peripheral Configuration
as below.

Fig:
Peripheral Configuration of BDTP Server

 Network
Connection/Network services:
Select Network Services, Select BDTP Server to edit Max Client.

 

Fig.
Network Connection of BDTP Server

 

Fig.
Network services of BDTP Server
   5.  BDTP Client Setting

  
   Set IP 192.168.1.2 of BDTP Client as below

Fig:
Peripheral Configuration of BDTP Client

  5.  BDTP Client Setting
For
the network service BDTP Client, the IP Addresses for the BDTP Servers in the
network from which the client is to collect information are defined. Select BDTP Client
in the list and click Edit to enter the settings.

 

Fig. Network services of BDTP Client

Leave a Reply